Cadet Lapel Pin (Standard)

Design by tdijk

(0)

0 out of 5
*
*
*
*
*

(1) Comments

Contact Designer

This pin should work with any standard-sized lapel pin clasp (not included). Note: Depending on the material you choose, the pin may have a somewhat rough texture. The 3D rendering is a representation of the model itself, but the printing process does introduce some texture. Update 2/8/13: The size of the pin has been slightly increased to offer a better fit with standard clasps (it was a hair too small to get a good fit).

cm: 1.908 w x 1.082 d x 2.538 h

in: 0.751 w x 0.426 d x 0.999 h

Comments

You must login to leave a comment

m1k3h5u says:

Flag as inappropriate

Hey! Love what you've done with the lapel looks good. I'm trying to make a lapel as well. Do you know what the shaft size for the clutch back pin? How does your fit? If you pass on that information that would be awesome! Keep up the good work!

February 20, 2013, 12:51 am