Sonar Servo Mount

Sonar Servo Mount 3d printed Mechanical parts Gift Guide Main View
Main View
Sonar Servo Mount 3d printed Mechanical parts Gift Guide Front View
Sonar Servo Mount 3d printed Mechanical parts Gift Guide Front View
Front View
Sonar Servo Mount 3d printed Mechanical parts Gift Guide Front view from Below
Sonar Servo Mount 3d printed Mechanical parts Gift Guide Front view from Below
Front view from Below
3d Model Viewer
Sonar Servo Mount 3d printed Mechanical parts Gift Guide
Sonar Servo Mount 3d printed Mechanical parts Gift Guide
Sonar Servo Mount 3d printed Mechanical parts Gift Guide Back View
Sonar Servo Mount 3d printed Mechanical parts Gift Guide Back View
Back View
Sonar Servo Mount 3d printed Mechanical parts Gift Guide Back Wide View
Sonar Servo Mount 3d printed Mechanical parts Gift Guide Back Wide View
Back Wide View
Sonar Servo Mount 3d printed Mechanical parts Gift Guide Main View
Sonar Servo Mount 3d printed Mechanical parts Gift Guide Main View
Main View
The part allows you to mount the Parallax Ping))) sensor on the Hitec HS-325HB Servo. It has been optimized for Shapeways printing with the Grey Robust material.

The activity light and connector pin outs are visible.

This part will require drilling and fasteners. Two M3x5mm and two M2x6mm screws are suggested. If you don''t have the necessary taps you can use nuts.

YouTube assembly Video is available here. http://www.youtube.com/watch?v=h5oXFVhrQr8
cm: 5 w x 2.7 d x 1.7 h
in: 1.969 w x 1.063 d x 0.669 h

Comments

 
Nice. I was thinking about something like this.
April 10, 2013, 2:50 pm
Quite sturdy, does not fit http://dx.com/p/hc-sr04-ultrasonic-sensor-distance-measuring-module-133696 well, but with a little effort it will fit quite nice. I'm happy with it !
February 14, 2013, 5:39 pm
 
  • Sandstone

    Delicate and grainy, with a coarse finish and sand-like color.

    $7.52

Favorited by