Clip-it Lightning US

  • White

    White nylon plastic polished to reveal a smooth matte finish.

    $9.73

CLIP-IT for iPhone Lightning US

Your iPhone 5 charge buddy on the go.

Clip-it for iPhone converts your iPhone charger to a wall dock; making sure that you can easily charge your phone at every wall socket. Unfurnished rooms, hotels and conference rooms are no longer a problem.

Clip-it makes use of your new Apple Lightning Connector to USB Cable. Simply snap Clip-it to your charger and slide the Lightning connector in to the tray. The tray makes it possible to take out your phone including the Lightning connector to hold it in your hand for incoming messages and afterwards you can easily dock it again.

Clip-it Lightning US is specially designed for the new iPhone 5 and the included Apple USB Power Adapter (US version).

The European version of Clip-it Lightning is available here.

A multipack of 5 units with reduced prices is available here.

A multipack of 10 units with reduced prices is available here.


Clip-it is manufactured by innovative 3D-printing in tough but lightweight polyamide. The surface has a fine texture. The product will be shipped in basic Shapeways packaging. Some powder residue from the 3D-printing process may be found on the product itself; if this is the case, it should be easy to clean off with small tooth sticks & brushes. When you ordered Clip-it in colour it might be wise to clean it with water under the tap, so the dyeing pigments that might still be on the product don’t colour your white Apple gadgets. For further information & support contact the Shapeways customer service.

Dimensions

IN: 1.083 w x 1.083 d x 1.083 h
CM: 2.75 w x 1.39 d x 3.1 h

Comments

 
Thanks glowitz!
February 11, 2014, 4:33 pm
Nice product! Well done.
October 26, 2013, 8:12 am