iPhone 5 case Rosette back

iPhone 5 case Rosette back 3d printed Accessories Cases
iPhone 5 case Rosette back 3d printed Accessories Cases shown in white, this features a charm simply attached by a jump ring. Sold seperatly
iPhone 5 case Rosette back 3d printed Accessories Cases shown in white, this features a charm simply attached by a jump ring. Sold seperatly
shown in white, this features a charm simply attached by a jump ring. Sold seperatly
iPhone 5 case Rosette back 3d printed Accessories Cases
iPhone 5 case Rosette back 3d printed Accessories Cases
3d Model Viewer
iPhone 5 case Rosette back 3d printed Accessories Cases
iPhone 5 case Rosette back 3d printed Accessories Cases
iPhone 5 case Rosette back 3d printed Accessories Cases
iPhone 5 case Rosette back 3d printed Accessories Cases
iPhone 5 case Rosette back 3d printed Accessories Cases
iPhone 5 case Rosette back 3d printed Accessories Cases
iPhone 5 case Rosette back 3d printed Accessories Cases
iPhone 5 case Rosette back 3d printed Accessories Cases
iPhone 5 case Rosette back 3d printed Accessories Cases
iPhone 5 case Rosette back 3d printed Accessories Cases
iPhone 5 case Rosette back 3d printed Accessories Cases
iPhone 5 case Rosette back 3d printed Accessories Cases
iPhone 5 case Rosette back 3d printed Accessories Cases render front
iPhone 5 case Rosette back 3d printed Accessories Cases render front
render front
iPhone 5 case Rosette back 3d printed Accessories Cases render detail
iPhone 5 case Rosette back 3d printed Accessories Cases render detail
render detail
This iPhone 5 case has been tested for several months now and works without flaw. This phone has been dropped several times with no dammage to phone or case.

The design features 2 rounded corners and 2 squared corners which have holes for a jump ring or lanyard. Shapeways nylon material offers good friction when in a pocket so it won't slide out easily. Case also fits very well in may car mount system.

Important! Always insert phone top first at an angle and snap case on toward bottom. To remove phone, reverse action by prying case off bottom first and then slide phone out. There are 4 slots on case for flexing. I did spray clear lacquer on the black case.

Also note, I have had one case that was a bit loose. Same file but it must have been printed in a different orientation. This I can not control. I simply put some masking tape strips on the inside to fill the gap. The ones pictured fit like a glove.
cm: 6.42 w x 1.286 d x 13 h
in: 2.528 w x 0.506 d x 5.118 h

Comments

 
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $42.16

Favorited by