Quuby - iPhone 4 / 4s case

Quuby - iPhone 4 / 4s case 3d printed Gadgets Cases

Quuby

This is the tank. 

Some say this battle-hardened case doesn't have the aesthetic appeal, the free flowing geometry or a cheery disposition when compared with its peer cases.........

 

.......but then it beat them up!

 

If your iPhones 4 / 4S worst enemy is you, Quuby will look after it.

My shop here

Material Information here

cm: 6.254 w x 1.234 d x 11.914 h
in: 2.462 w x 0.486 d x 4.691 h

Comments

 
@Jon49 Hello Jon, the the pattern on the case at its thinnest is 0.8mm. I appreciate that may seem a little fragile but because it is supported by up to 2mm wall thickness running around/through it i have never seen one break. I used to make very intricate yet fragile cases but soon realised they were not suitable for their purpose. So now I print everything before putting it up for sale, to test fit and durability. All that being said, yes if you run over it in a car it is unlikely to remain in one piece :) Hope that helps.
February 6, 2014, 3:50 pm
Is any part of this case less than 1mm thick? Just wondering about the strength.
February 2, 2014, 4:20 pm
@hungrymutt Thanks for the interest, always appreciated ....Ill look into it. But probably wont get round to it till the new year. Sorry
December 6, 2012, 11:16 pm
Have you thought about designing this for an iPhone 5? I would be interested in that!
December 1, 2012, 10:35 pm
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $20.85

Favorited by