This is the tank. 

Some say this battle-hardened case doesn't have the aesthetic appeal, the free flowing geometry or a cheery disposition when compared with its peer cases.........


.......but then it beat them up!


If your iPhones 4 / 4S worst enemy is you, Quuby will look after it.

My shop here

Material Information here


IN: 2.462 w x 0.486 d x 4.691 h
CM: 6.254 w x 1.234 d x 11.914 h


Sign In or Join to comment.
@Jon49 Hello Jon, the the pattern on the case at its thinnest is 0.8mm. I appreciate that may seem a little fragile but because it is supported by up to 2mm wall thickness running around/through it i have never seen one break. I used to make very intricate yet fragile cases but soon realised they were not suitable for their purpose. So now I print everything before putting it up for sale, to test fit and durability. All that being said, yes if you run over it in a car it is unlikely to remain in one piece :) Hope that helps.
February 6, 2014, 3:50 pm
Is any part of this case less than 1mm thick? Just wondering about the strength.
February 2, 2014, 4:20 pm
@hungrymutt Thanks for the interest, always appreciated ....Ill look into it. But probably wont get round to it till the new year. Sorry
December 6, 2012, 11:16 pm
Have you thought about designing this for an iPhone 5? I would be interested in that!
December 1, 2012, 10:35 pm


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.