biikparts Flanged Spacer

biikparts Flanged Spacer 3d printed spacer installed
spacer installed
biikparts Flanged Spacer 3d printed spacer installed
biikparts Flanged Spacer 3d printed spacer installed
spacer installed
biikparts Flanged Spacer 3d printed
biikparts Flanged Spacer 3d printed
3d Model Viewer
biikparts Flanged Spacer 3d printed
biikparts Flanged Spacer 3d printed
biikparts Flanged Spacer 3d printed
biikparts Flanged Spacer 3d printed
biikparts Flanged Spacer 3d printed
biikparts Flanged Spacer 3d printed
biik_parts spacer v1.04 (WITH LIP) for 1 1/8" steerer tube

This is a spare or additional spacer to compliment the biikparts iPhone Mount. THIS MODEL HAS AN INNER LIP, TO SUIT STACKING ON OTHER SPACERS. IT WILL NOT GO OVER THE STEERER TUBE. (SEE DIAGRAM)
You can install these spacers on as many bikes as you want, and then click your compatible mounts on and off as required. The 'strong and flexible'material has proved structurally very sound and these spacers have travelled hundreds of kilometres on bikes already without a scratch or a dent. A must for anyone who has a biikparts iPhone Mount and more than one bike.

Refer to the biikparts iPhone Mount page for installation instructions.
Please Note: after version 1.02, the biikparts mounting system was changed to a right hand thread. Please contact me if you need the old left-hand thread version
www.nickflutter.com www.biik.com.au
cm: 3.786 w x 4.018 d x 0.78 h
in: 1.491 w x 1.582 d x 0.307 h

Comments

 
Here is the spacer installed on my Diamondback Overdrive 29er
February 16, 2013, 6:38 pm
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $5.88

Favorited by