HOn3 25 foot Pipe Gondola

HOn3 25 foot Pipe Gondola 3d printed Model trains Miniatures
A gondola with the end planks removed. For long loads such as pipes or logs. There are supports for a handbrake wheel and shaft (not supplied) at one end (of the side planks) that need to be drilled out. Based on the rolling stock of the Ohio River & Western Railway. This model is designed for HOn3 couplers (Kadee 714).These will have to be glued in place as the floor is only 1mm thick (unless you have a better idea).
Instructions
Now with separate brake parts (air and vacuum), to be found attached to the bolsters. Remove these and fit the appropriate one.
cm: 2.86 w x 9 d x 2.704 h
in: 1.126 w x 3.543 d x 1.065 h

Comments

 
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $11.97

Favorited by