High detailed model of car's brake disc. Using reference models and 2D drawings of a basic brake disk I created this model.
When you have got your models in your hands after getting them printed here assemble them by placing center disc in side the main larger disc (this should be a tight fit). Then place the caliper* over the main part of the break anywhere on the disc. This should be a very tight fit and you should place it where you think you should.
I will be making loads of improvements over time.
For the whole kit you will need to order all of the parts listed below:
Part 1: http://www.shapeways.com/model/679959/
Part 2: http://www.shapeways.com/model/679960/brake-disc-part-2.html
Part 3: http://www.shapeways.com/model/679961/brake-disc-part-3.html
12.96 w x
12.96 d x
5.102 w x
5.102 d x