Badge Holder (Exhibition)

Badge Holder (Exhibition) 3d printed Jewelry Buttons
Badge Holder (Exhibition) 3d printed Jewelry Buttons Artist rendering of assembled items. Your badge will look different depending on what material you choose.
Badge Holder (Exhibition) 3d printed Jewelry Buttons Artist rendering of assembled items. Your badge will look different depending on what material you choose.
Artist rendering of assembled items. Your badge will look different depending on what material you choose.
3d Model Viewer
Badge Holder (Exhibition) 3d printed Jewelry Buttons
Badge Holder (Exhibition) 3d printed Jewelry Buttons
This is the lower portion of the Ministry of Magic Visitor Badge that was seen in various exhibitions of the films and their props. * Please note that you will have to use a piece of wire (that is not provided) to connect the two pieces of the visitor's badge. Copper wire or even a paper clip work very well.
cm: 11.002 w x 0.374 d x 7.942 h
in: 4.331 w x 0.147 d x 3.127 h

Comments

 
 
  • Black Strong & Flexible

    Black nylon plastic with a matte finish and slight grainy feel.

    $20.00