Fans and Vents 6mm

Fans and Vents 6mm 3d printed SciFi Miniatures
cm: 3.788 w x 3.394 d x 0.304 h
in: 1.491 w x 1.336 d x 0.12 h

Comments

 
@EvilDave - trying to clarify why this is with Shapeways, given that they've been printed before. I've just been told that our Power Pylons are now being rejected, despite having been printed 40+ times in the past :-/
December 11, 2013, 12:42 pm
I just got told the same thing when I tried to order it in FD.
December 11, 2013, 12:40 pm
@Covertwalrus - thanks - it was rejected because some of the parts are too small :-( I've uploaded a new version with the parts sprued together - makes it a fraction more expensive but it should get through now I hope.
September 4, 2013, 10:32 am
Just been informed that these will NOT print in Frosted Detail; Might try again in FUD but thought I'd give a heads-up.
September 4, 2013, 10:22 am
 
  • Frosted Detail

    Matte translucent plastic with fine print lines that reveals small details.

    $10.68

Favorited by