Edge of Destruction front facing

Edge of Destruction front facing 3d printed Jewelry Keychains Note that this test print does not have the loop
Note that this test print does not have the loop
Edge of Destruction front facing 3d printed Jewelry Keychains Note that this test print does not have the loop
Edge of Destruction front facing 3d printed Jewelry Keychains Note that this test print does not have the loop
Note that this test print does not have the loop
3d Model Viewer
Edge of Destruction front facing 3d printed Jewelry Keychains
Edge of Destruction front facing 3d printed Jewelry Keychains
This is an approximately 3 inch long sword designed to be used as a keychain or jewelry piece. It features a hole at the hilt of the sword facing to the side. A thin chain or string can be run through the hole and the sword can be worn as a necklace facing forward. This item is available in a wide variety of materials, please research the material you are choosing, as I have not printed test models in all of them. The image shows the model in stainless steel.
cm: 0.954 w x 7.912 d x 0.742 h
in: 0.376 w x 3.115 d x 0.292 h

Comments

 
Turned out nicely!
July 19, 2013, 11:25 am
 
  • Stainless Steel

    Bronze-infused stainless steel with visible print lines and rough feel.

    $17.00