Ver.2 Tritium Pedal Bead (Silver/Brass/Plastic)

Ver.2 Tritium Pedal Bead (Silver/Brass/Plastic) 3d printed Jewelry Gadgets
Small pedal shaped tritium vial holding decorative bead with large side cut-outs, designed to take two of the 2.5x10mm tritium vials (tritium vials not included).

This model is sized for printing in either sterling silver, brass or one of the various plastics available.

The central hole is 5mm in diameter and should just be wide enough for two lengths of 550 paracord.

The tritium vials should be set using a UV activated optically clear adhesive such as Norland 61 or Loctite glass bond. These adhesives will cure in direct sunlight in an hour or so.

There are some more photos of this object and other examples of my work, both 3D printed and otherwise, on my 'Tofty' facebook page.
cm: 1.586 w x 0.706 d x 1.276 h
in: 0.624 w x 0.278 d x 0.502 h

Comments

 
Done, thanks for pointing that out, i hadn't noticed the new colours.
October 19, 2012, 2:33 pm
Curious if you will be adding the new blue color to the choices? :)
October 18, 2012, 11:55 pm
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $3.37

Favorited by