CC3DCase lower

CC3DCase lower 3d printed Mechanical parts Robotics
This is the bottom part of the OpenPilot CopterControl CC3D case. You also need the top part (CC3DCase upper) and (optionally) the base clip (Case base 1 v1). Note that this case is for the CC3D only. The base clip is common to both CC and CC3D versions.

More info here: http://wiki.openpilot.org/display/Doc/CopterControl+case and http://wiki.openpilot.org/display/Doc/CC3D+Case

CC3D complete set?

+ +




cm: 4 w x 0.44 d x 4 h
in: 1.575 w x 0.173 d x 1.575 h

Comments

 
@jes1111 thanks, will give it a go later!
May 9, 2013, 4:05 pm
@henrynewtondunn - make sure the base clip is screwed down to a rigid surface - that makes a surprising difference to the fit.
May 9, 2013, 8:33 am
I got this and it doesn't fit together properly as the tolerances are too tight ... the top section and the bottom section are fine but the clip doesn't work. Guess I'll have to get busy with the craft knife.
May 9, 2013, 4:48 am
I would love to see a photo of a 3d print as this seems super popular.
January 1, 2013, 1:46 am
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $6.27

Favorited by