CC3DCase lower

Design by jes1111

(2)

4 out of 5
*
*
*
*
*

(4) Comments

Contact Designer

This is the bottom part of the OpenPilot CopterControl CC3D case. You also need the top part (CC3DCase upper) and (optionally) the base clip (Case base 1 v1). Note that this case is for the CC3D only. The base clip is common to both CC and CC3D versions.

More info here: http://wiki.openpilot.org/display/Doc/CopterControl+case and http://wiki.openpilot.org/display/Doc/CC3D+Case

CC3D complete set?

cm: 4 w x 0.44 d x 4 h

in: 1.575 w x 0.173 d x 1.575 h

Comments

You must login to leave a comment

henrynewtondunn says:

Flag as inappropriate

@jes1111 thanks, will give it a go later!

May 9, 2013, 4:05 pm

jes1111 says:

Flag as inappropriate

@henrynewtondunn - make sure the base clip is screwed down to a rigid surface - that makes a surprising difference to the fit.

May 9, 2013, 8:33 am

henrynewtondunn says:

Flag as inappropriate

I got this and it doesn't fit together properly as the tolerances are too tight ... the top section and the bottom section are fine but the clip doesn't work. Guess I'll have to get busy with the craft knife.

May 9, 2013, 4:48 am