TFPrime Soundwave Tentacles

TFPrime Soundwave Tentacles 3d printed Games Maker/DIY
cm: 3.08 w x 4.6 d x 4.76 h
in: 1.213 w x 1.811 d x 1.874 h

Comments

 
having a lot of trouble getting the pieces to snap together, my finger tips are killing me, not sure if it was a bad print. but i waited too long for the print to try again. i hope others have better luck
August 28, 2013, 4:12 am
What is the material used for the ones in the slideshow?
June 9, 2013, 1:05 pm
@zoso1900 Excellent, I plan on purchasing this set when I get some more funds and I will keep an eye out for the upgrade. Thanks
February 8, 2013, 4:25 pm
@Ridl85 this has been requested by a few people but I have not had a chance to design how this would work. I thick it would be very possible and if I can get it to work I will offer the claw as its own upgrade piece. Thanks for looking and if you order I hope you enjoy the product.
February 8, 2013, 11:12 am
Is it at all possible to augment the claws on the end to give them articulation, or would that be too difficult/too costly?
February 8, 2013, 3:28 am
Oh, definitely added to my wishlist! Dang, that list is getting expensive....
February 8, 2013, 3:24 am
There's a very strong possibility I will buy this figure entirely because of these!
December 14, 2012, 12:16 pm
nice work
September 29, 2012, 9:22 pm
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $15.00

Favorited by