Bicycle Cable Stop 35mm - Bamboo / Carbon Frame

by mikefford
This is a brake or gear cable stop designed for use on a bamboo, wooden or carbon fibre bicycle where fittings such as these need to be glued and screwed on, rather than welded. This cable stop has two countersunk screw holes with 3mm diameter to allow for a M3 screw to be used to affix to the bicycle frame. The bottom of this cable stop is curved for tubing 35mm in diameter, so it's suitable for use on down, top and seat-tubes. See my other smaller diameter design for use on seat and chain stays

Dimensions

IN: 0.617 w x 1.635 d x 0.551 h
CM: 1.566 w x 4.152 d x 1.4 h

Comments

Sign In or Join to comment.
 
Can you make one with a flat bottom that could be screwed into a wood block I am using on my trike for a derailleur mount?
February 27, 2014, 3:39 am
Awesome, just featured it on the Shapeways Blog.. http://www.shapeways.com/blog/archives/1630-3D-Printed-Bicycle-Cable-Stop-to-Attach-to-Bamboo-Carbon-Fibre-Frames.html
September 17, 2012, 2:12 pm
 
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.