Bicycle Cable Stop 35mm - Bamboo / Carbon Frame

Design by mikefford

(1)

5 out of 5
*
*
*
*
*

(1) Comments

Contact Designer

This is a brake or gear cable stop designed for use on a bamboo, wooden or carbon fibre bicycle where fittings such as these need to be glued and screwed on, rather than welded. This cable stop has two countersunk screw holes with 3mm diameter to allow for a M3 screw to be used to affix to the bicycle frame. The bottom of this cable stop is curved for tubing 35mm in diameter, so it's suitable for use on down, top and seat-tubes. See my other smaller diameter design for use on seat and chain stays

cm: 1.566 w x 4.152 d x 1.4 h

in: 0.617 w x 1.635 d x 0.551 h

Comments

You must login to leave a comment

duann says:

Flag as inappropriate

Awesome, just featured it on the Shapeways Blog.. http://www.shapeways.com/blog/archives/1630-3D-Printed-Bicycle-Cable-Stop-to-Attach-to-Bamboo-Carbon-Fibre-Frames.html

September 17, 2012, 2:12 pm