Quadcopter LED Running Light Bracket v1 - Sextet

Quadcopter LED Running Light Bracket v1 - Sextet 3d printed
This is a small bracket intended for attaching LED lights to a Hexacopter frame that uses square aluminum booms. It will hold two 5mm LEDs. It can be attached with a single screw/bolt or a zip tie (the notches are to keep it from slipping out from under the zip tie). Set of 6.

A note regarding ordering in the "polished" materials. The Polishing process enlarges the holes a very small amount. While most 5mm LEDs will still friction fit into them, a dab of hot melt glue may be required to keep them from vibrating loose.
cm: 8.7 w x 1.9 d x 1.8 h
in: 3.425 w x 0.748 d x 0.709 h


  • Black Strong & Flexible

    Black nylon plastic with a matte finish and slight grainy feel.