Raspberry Pi Carrier Frame

Raspberry Pi Carrier Frame 3d printed Mechanical parts Gadgets
cm: 8.5 w x 0.7 d x 5.8 h
in: 3.346 w x 0.276 d x 2.283 h


This is an adapter plate with four M3 fixing holes set to fit onto standard 0.1 inch (2.54mm) interval matrix board. Actually, it will also fit onto a 5.08mm interval matrix. The Raspberry Pi then clips securely onto the frame with minimum stand off. The product was generated in the belief that a significant proportion of Raspberry Pi's will be part of a project that incorporates other electonics & needs to be housed in a larger box. Matrix board (Veroboard) is the standard weapon of choice for one off and prototype designs. If anyone buys one or more of these, do please contact me if you encounter any snags with the design, or if you have any suggestions for improvement. This has been created from measurements taken from an actual Raspberry Pi, model B. I think there's not a bad chance that the makers may introduce revisions from time to time. I don't know whether the fittings are in standardised positions that will not alter, so I would like feedback about any fitting problems.
June 11, 2012, 1:23 pm
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.


Favorited by