All models A low profile case for the Raspberry Pi with sloped edges. Large open logo so the pcb board is visible and an open bottom frame with LEGO feet. The pcb board is clicked in the bottom part. The USB connector will stick out the front. Along the side of the GPIO connector there are some holes, so it is easy to cut out, in order to get a flatcable out. Case consist of 1.4 mm walls which makes it more expensive but is far more solid It fits my production RPi perfectly. There still can small variations depending on the placement of the components. If you would like to purchase this, please note that if it does not fit, understand that I cannot and won't give a refund. Minor adjustments can be done with an exacto knife if it doesn't fit exactly.