Dock I Phone 4 for Toyota Prius

Dock I Phone 4 for Toyota Prius 3d printed Cases Vehicles
cm: 6.194 w x 8.816 d x 4.818 h
in: 2.439 w x 3.471 d x 1.897 h

Comments

 
@bartv I updated the model, maybe you are interested the model.
February 11, 2013, 5:13 pm
Good planning does not always ensure a good result though ;-) You really should have it printed so you can test it.
January 22, 2013, 9:10 am
@bartv You're right, the product was not tested, but it was very well planned. Here's a few requirements: Model must fit a build area of 5x5x6 inches Design must be one piece and able to be printed on Projet 3D Printer Must not have moving parts. Dock should appear to be an integrated part of the car Dock should be designed to attach to the dash of the car using double sided tape Design must not require alterations to any part of the car Dock must be located near the steering wheel and in line of sight of the driver without obstructing the view of the road. The screen of the iPhone must face directly towards the eyes of the driver’s head. Design must accommodate space for the original iPhone power cable, which we will insert and glue into the prototype. I will develop a standard model for the IP5, NEXUS 4, G OPTIMUS PRO and HTC BUTTERFLY wait .. I can also develop a model or product unique to you ok?
January 22, 2013, 2:52 am
Right, well I'm a little reluctant to spend €92 on an untested product though :) Oh, and do you plan to have an iPhone 5 model as well?
January 21, 2013, 8:29 am
@bartv was only performed trepidations simulations in 3D software. I bring this proposal intended to make it near the driver but without cluttering the view from the windshield. This version is the I Phone 4 ok?
January 19, 2013, 1:37 am
Did you test it? I really like the placement, all other kits place the iphone way too far out of sight.
January 18, 2013, 10:40 am
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $36.46