80mm Fan Mount for Gyro the Cube (5cm)

80mm Fan Mount for Gyro the Cube (5cm) 3d printed
Mount this part on a high airflow 80mm PC-fan.
Click your Gyro the Cube in the Center.
Watch it move on its own :-)

Please Note!
Fan and grills not included!
It works best if the first axles on the cube is aligned vertically.
The motion produced by this is not (yet) very interesting.
But after tinkering with this for a very long time, I owe it to the fans to pre-release it.
Thank you for your patience.

Use fan grill on both side of your fan to prevent injuries!
Make sure the Gyro the Cube is mounted tightly before applying power to the fan!
Use ate your own risk!
If you don't know what you are doing, then PLEASE DON'T!
To control motion use a PWM controller for your fan.
cm: 8.24 w x 8.24 d x 1 h
in: 3.244 w x 3.244 d x 0.394 h


  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.


Favorited by