Punch upgrade kit Mk2 11.05.12

Punch upgrade kit Mk2 11.05.12 3d printed SciFi Miniatures
cm: 2.8 w x 2.184 d x 2.868 h
in: 1.102 w x 0.86 d x 1.129 h

Comments

 
Is this a better scale for the club figure?
May 14, 2013, 2:37 am
Ok, First off I suggest ordering in Ultra Frosted detail so the details of the model actaully show up. The top cap works fine on mine, and is what it is due to the size restrictions of the original mold. Finally, all the rubbing/contact areas are made 0.1mm smaller to allow for undercoat, top coat paint and sealent.
June 25, 2012, 7:48 am
hope u could do revise so that wont waste.
June 24, 2012, 9:16 am
i get this set today in WFS material. something wanna feeback to u. first of all, the 'hat' is too small or too flat compare with the faces, it s like they wear a wrong size cap. besides, the lock of the hands re little bit smaller, so that it s loose when installed.
June 24, 2012, 9:15 am
 
  • Frosted Ultra Detail

    Matte translucent plastic that showcases fine and intricate details.

    $18.55

Favorited by