Servo Mount (Losi Micro Stock Servo)

Servo Mount (Losi Micro Stock Servo) 3d printed Robotics Gadgets
This is a stock Losi Micro servo mount for custom chassis'. This will secure your servo to the chassis without the use of thick two-sided tape. This has been tested from a few customer's and appears to be a direct fit over the stock Losi servo. Please refer to the comment's below on other slight modification's for other servo's. Please comment or visit http://www.microtforum.com with feedback or question's or problem's with this part. Thanks Be sure to visit www.losimicroinfo.com for great information for the Losi micros.
cm: 2.8 w x 1.58 d x 1.4 h
in: 1.102 w x 0.622 d x 0.551 h

Comments

 
Good stuff. Fits the Losi micro servo like a glove. With an HK HXT500 servo there will be a bit of play (side to side), easily fixed with a shim or by screwing the servo tabs into the mount. Highly recommended.
October 19, 2013, 3:34 pm
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $3.67

Favorited by