Smaller Earring RBS

Smaller Earring RBS 3d printed Art Jewelry printed08
printed08
Smaller Earring RBS 3d printed Art Jewelry Front Right
Smaller Earring RBS 3d printed Art Jewelry Front Right
Front Right
Smaller Earring RBS 3d printed Art Jewelry printed
Smaller Earring RBS 3d printed Art Jewelry printed
printed
Video
3d Model Viewer
Smaller Earring RBS 3d printed Art Jewelry
Smaller Earring RBS 3d printed Art Jewelry
Smaller Earring RBS 3d printed Art Jewelry printed07
Smaller Earring RBS 3d printed Art Jewelry printed07
printed07
Smaller Earring RBS 3d printed Art Jewelry printed08
Smaller Earring RBS 3d printed Art Jewelry printed08
printed08
I think this is the smallest I can possibly make the Earring RBS given shapeways minimum wall thickness limitations for white strong and flexible. The frame is 1mm and the rails are 0.8 mm. Yes, I know 0.7 is real minimum but I don't want to risk it. Again, I haven't printed and tested it yet so I'm not sure if it works, but it should. It is very small at 1 inch wide by 2.25 inches tall. There is a loop at the top for hooking to an earring or it will also stand on its own. A very unique earring! Don't forget that if you want it for an earring you need to purchase two (one for each ear). You'll notice that this one is a little smaller than the earring rbs I uploaded previously. To play with it, you'll need to detach the attached 5 marbles. http://www.youtube.com/watch?v=-as24TSv2-U

cm: 2.518 w x 2.738 d x 5.75 h
in: 0.991 w x 1.078 d x 2.264 h

Comments

 
 
Not For Sale
Favorited by