Smaller Earring RBS Marble Run Rolling Ball Sculpt

by swirlingbrain
Smaller Earring RBS Marble Run Rolling Ball Sculpt 3d printed Art Jewelry printed08
printed08
Not For Sale
I think this is the smallest I can possibly make the Earring RBS given shapeways minimum wall thickness limitations for white strong and flexible. The frame is 1mm and the rails are 0.8 mm. Yes, I know 0.7 is real minimum but I don't want to risk it. Again, I haven't printed and tested it yet so I'm not sure if it works, but it should. It is very small at 1 inch wide by 2.25 inches tall. There is a loop at the top for hooking to an earring or it will also stand on its own. A very unique earring! Don't forget that if you want it for an earring you need to purchase two (one for each ear). You'll notice that this one is a little smaller than the earring rbs I uploaded previously. To play with it, you'll need to detach the attached 5 marbles. http://www.youtube.com/watch?v=-as24TSv2-U

Dimensions

IN: 0.991 w x 1.078 d x 2.264 h
CM: 2.518 w x 2.738 d x 5.75 h

Comments

Sign In or Join to comment.
 
 
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.