A replacement latch handle for a window or roof scoop. This was modeled after the original latch that came with a Subaru aftermarket roof scoop. The original tends to break loose where the spring sits inside the handle or where the holes are for the pins. In this reproduction there are a couple of differences. 1) The edges are not indented. Hopefully this will prevent the pin holes from breaking. 2) The indentions for the spring on the under side are a little deeper. Try out a plastic print and if it works out have it printed in stainless steel and never buy another one! Also, I believe this option is cheaper than buying one from Japan. Please keep in mind that this is sold as a prototype and there is no guarantee it will work for your application, although it did for my friend who supplied the photos.

Dimensions

IN: 0.969 w x 3.159 d x 0.72 h
CM: 2.46 w x 8.024 d x 1.828 h

Comments

Sign In or Join to comment.
 
Works wonderful! been running one for quite awhile.
February 26, 2013, 8:23 pm
 
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.