HexaCopter CenterBlock v1 1

HexaCopter CenterBlock v1 1 3d printed Mechanical parts Miniatures
A center block for mounting 10x10mm aluminium arms for a hexacopter. With 10mm height, the block can fit between mounting plates and still let the arms be detachable.
cm: 6 w x 5.568 d x 1 h
in: 2.362 w x 2.192 d x 0.394 h

Comments

 
@AreTysland I like it. You should make arms also with motor mount built in.
December 1, 2013, 11:52 pm
@Bustamytool I attached the center to an 'AluBond' mounting plate (it's somewhat stiffer that aluminium and very easy to work with); kind of circular with 15cm diameter. The 30cm arms slide onto the center block and fasten to the mounting plate with one screw each. I thought of using two plates and sandwich the arms in between, but found that one place was solid enough. This way the arms are easily detachable - just by removing one screw and unhook three wires on each.
December 1, 2013, 10:34 pm
@AreTysland How do you recommend I strengthen it? Can you make a 600mm solid frame?
December 1, 2013, 3:35 am
@Bustamytool The center block is solid enough, but I would not have let it carry all the strain alone.
November 30, 2013, 8:34 pm
Are these strong mainframes?
November 30, 2013, 7:34 pm
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $14.37

Favorited by