Mecha Ring (size 15ish in metal)

Design by MaxSMoke777

(15)

3.6 out of 5
*
*
*
*
*

(7) Comments

Contact Designer

Mecha Ring in Steel

Steel, on my Finger

This is the Silver version, on my hand.

This is the Silver version.

Mecha Ring in Steel

This ring is about Men's Ring Size 15+, after metal shrinkage. It fits the largest finger on my rather large hands without a problem.

(UPDATE: I've made some changes that should get around that printing error Shapeways is now giving. I'll test it as soon as I have the money to buy new prints)

cm: 2.834 w x 0.956 d x 2.858 h

in: 1.116 w x 0.376 d x 1.125 h

Comments

You must login to leave a comment

MaxSMoke777 says:

Flag as inappropriate

Not to be a D**K, but I get like $1 from this (shapeways makes all of the real profit), and I have alot of *actual* work going on. I'll see what I can do when time allows. I only do this as a favor to you.

February 6, 2013, 1:00 pm

Iggyfigs says:

Flag as inappropriate

@MaxSMoke777 Max, it would be awesome if you could upload the pair of rings for me. I would really appreciate it, thanks!

February 6, 2013, 4:35 am

cbesposito says:

Flag as inappropriate

I love the ring, but when you say it's 15+ size, do you mean "USA size" as in http://www.onlineconversion.com/ring_size.htm? A 15+ size isn't even listed there...

January 20, 2013, 3:34 am

Iggyfigs says:

Flag as inappropriate

@MaxSMoke777 I was planning to have them in gold plate, but that is plated steel so it still will shrink, yes? The final initial diameters should be about 0.84 and 0.72. I unfortunately cannot afford two silver prints even though I think they look amazing in silver (unless if the two models are together it's only $50-60)

January 6, 2013, 9:41 pm

MaxSMoke777 says:

Flag as inappropriate

@Iggyfigs I have a smaller version available, but when printed in Steel, some of the parts get very fragile and might not survive the "Green" state of the Steel production. Steel prints formed from metal power, coated in a bit of plastic, and then they use lasers to melt the plastic to hold the metal powder together. This "Green" print is then fired in a Kiln until the metal binds together, and the plastic is vaporized. So I can make a smaller version, but it's possible bits might not come through. If you want to take that chance, send me a measurement of the interior diameter, in millimeters, of rings that fit you best. I suggest using calipers. Ring size charts can vary from county to country, region to region, sex to sex, so they ain't always very helpful. There's 3% to 5% shrinkage in Steel prints (from the plastic burn off), so if you want Steel, I'll have to figure that in as well.

January 6, 2013, 8:00 pm

Iggyfigs says:

Flag as inappropriate

Hey Max, is it possible you could make the Mecha Ring in size 12 and 8?

January 6, 2013, 7:34 pm

umbe0471 says:

Flag as inappropriate

Great design, I like it .

December 28, 2009, 1:16 pm