This is a replica of the piston in Minecraft, there is a small crank on the side of it which you can turn and then it will extend, it goes about half way out. This particular version was actually designed with silver in mind as the printing material, but would work with any material that has a min wall thickness of 0.6mm or less. Assembly required and its a very simple assembly. glue might be needed to close it up. NOTE: this model has not been printed yet, it is not guaranteed to work, but Im quite sure it will :)


IN: 1.054 w x 0.394 d x 0.815 h
CM: 2.676 w x 1 d x 2.07 h


Sign In or Join to comment.
@mastercake It has a small handle you can turn to extend/retract the piston. You would get all the pieces in the picture in a plastic bag, then you can assemble them and it should work. You would need to glue the lid and handle if you want it ti stay together properly.
December 6, 2013, 1:13 pm
How exactly does this work and what exactly would i get if i buy this?
December 6, 2013, 1:08 am


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.