This is a replica of the piston in Minecraft, there is a small crank on the side of it which you can turn and then it will extend, it goes about half way out. This particular version was actually designed with silver in mind as the printing material, but would work with any material that has a min wall thickness of 0.6mm or less. Assembly required and its a very simple assembly. glue might be needed to close it up.
NOTE: this model has not been printed yet, it is not guaranteed to work, but Im quite sure it will :)
cm:
2.676 w x
1 d x
2.07 h
in:
1.054 w x
0.394 d x
0.815 h
Select Country
$ United States
Material Options
-
White Strong & Flexible Polished
$5.98
-
White Strong & Flexible Polished
$5.98 -
Black Strong & Flexible
$5.89 -
Coral Red Strong & Flexible Polished
$6.23 -
Hot Pink Strong & Flexible Polished
$3.23 -
Royal Blue Strong & Flexible Polished
$3.23 -
Violet Purple Strong & Flexible Polished
$6.23 -
Frosted Ultra Detail
$10.27 -
Frosted Detail
$9.55 -
White Detail
$7.44 -
Black Detail
$7.44 -
Transparent Detail
$7.44 -
Silver Glossy
$51.00 -
Silver
$46.00 -
Alumide
$5.64
Comments