Vesuvius Twister Head

Vesuvius Twister Head 3d printed Mechanical parts Miniatures Printed in Stainless Steel
Printed in Stainless Steel
Vesuvius Twister Head 3d printed Mechanical parts Miniatures Here it is attached to the Vesuvius flashlight
Vesuvius Twister Head 3d printed Mechanical parts Miniatures Here it is attached to the Vesuvius flashlight
Here it is attached to the Vesuvius flashlight
Vesuvius Twister Head 3d printed Mechanical parts Miniatures Printed in Stainless Steel
Vesuvius Twister Head 3d printed Mechanical parts Miniatures Printed in Stainless Steel
Printed in Stainless Steel
3d Model Viewer
Vesuvius Twister Head 3d printed Mechanical parts Miniatures
Vesuvius Twister Head 3d printed Mechanical parts Miniatures
This is an add-on head for the Peak LED Solutions Vesuvius flashlight. The head accomplishes three things. 1) It prevents the flashlight from rolling when on a flat surface. 2) It allows it to head-stand with high stability. 3) It makes it much easier to turn the flashlight to full on (since this requires a lot of force). Due to 3d printing tolerances there will be a slight gap between the flashlight head and this add-on. You can use a small amount of conductive tape to make it a tight fit.
cm: 2.28 w x 2.032 d x 1.35 h
in: 0.898 w x 0.8 d x 0.531 h

Comments

 
 
  • Stainless Steel

    Bronze-infused stainless steel with visible print lines and rough feel.

    $18.28

Favorited by