MP Seeker hands (peg wrist variant)

MP Seeker hands (peg wrist variant) 3d printed Games Toys rear view.
rear view.
  • White

    White nylon plastic with a matte finish and slight grainy feel.


Version 1.5

Edit: Added spare fingers. Just in case!
A variant of the hands done for the Masterpiece Seeker figure, but this version has its wrist joint replaced with a ridged peg. The wrist peg is 5mm in diameter and peg section is 7mm long.


IN: 1.723 w x 1.723 d x 1.723 h
CM: 4.376 w x 5.786 d x 1.35 h


These are fantastic and worth the money A*********. I had no problem building these but after all i am a pro. Just remember to clean out any dust from the fingers before try to fit them. Thank you for uploading these and hope to buy many more. Many thanks Dawgstar
April 27, 2012, 3:39 pm