This is the stem and outer petals of a flower, there is a "K" at the base. The complete flower requires another part called "K" which has also been uploaded. I printed this part out once in strong and flexible and it turned out well in my opinion. One caution, white strong and flexible flexes over time so the whole flower starts to slowly tilt over multiple weeks, so I let it lean on something which keeps it straight. Another caution, the stem consists of skinny sections which may not have sufficient strength when printed in other plastics. Lastly, the base should be glued onto a surface as it is relatively small and light compared with the flower. I glued it to a round piece of plexiglass.