A09 N, Nn3 link and pin couplers, cast iron x48

  • Frosted Ultra Detail

    Matte translucent plastic that showcases fine and intricate details.

    $12.00

48 N scale drawheads for link and pin couplers. Larger than the A08 couplers, so large for Nn3. This style was made of cast iron, most common after 1860. Shown in photo with our Allen trucks part T82.

Body mount using #00 screw or glue in same location as a MicroTrains or similar coupler. A shim may be required for some models. Extend from car end about 3.4mm.

Though they can't accomodate real links, they can be made to operate using a U- or wishbone-shaped wire, preferably flat, connected through the pin holes (0.6mm/.024" diameter). Pin holes will accomodate .016" wire.
Because of their small size and fine detail, Frosted Ultra Detail is the preferred material. Clean with soapy water or alcohol before painting with acrylics or enamel. Use Bestine rubber cement remover if particularly greasy. See also A08 N wrought iron drawheads and A04, A06 working link and pin couplers. Contact panamintmodels@aol.com for other quantities or painted models.

Dimensions

IN: 1.212 w x 1.212 d x 1.212 h
CM: 3.078 w x 1.552 d x 1.344 h

Comments

 
Just received my 1st set, ordered in Frosted Ultra Detail, detail is beautiful, arrived on West Coast of US a day and a half ahead of schedule. I can hardly wait to start painting and installing them...
August 13, 2012, 7:57 pm