Gyro the Cube
An original design by Virtox
This kinetic sculpture
is inspired by the unlimited freedom of 3d printing.
It wobbles and turns with a slight movement of the hand.
Now give it a good spin or puff of air and it erupts in erratic and wild behavior.
Watch the video to see it go!Corner stand
is available separately.Impossible?
At the dawn of 3d printing it was accused of being fake
or simply impossible
Seriously, check out the Youtube comments
for a good laugh!
But for real product reviews, see the comments on the bottom of this page.
And after a little over 5 years, Gyro the Cube is already considered a classic in 3d printing
This is the 5cm / 2" version.Not big enough?
Get the Large (7.5cm / 3" version) version, starting at $50.
Or the Extra Large (10cm / 4" version) one, starting at $100!Can't live without it?
Why not get a key-fob
too?Still not enough?
Inquire for a custom made version or see the Gyro the Forms
section for other shapes and sizes.Instructions
The sculpture is composed of four concentric cubes, each one spinning around a different axis.
But it needs to be aligned after you receive it:
Each inner cube has two knobs which need to be placed into the corresponding clamps in the parent cube. It's easiest to start with the inner most and continue outward.
And then... spin it away !Note
Do not be alarmed if your cube will not run smoothly at first!
Because of minor variations in the 3d printing process,
sometimes a fresh cube needs to wear in a little, but it will loosen up very quickly.
In the example video I am only blowing on it, to make it move, it's that smooth.
Be a little careful with the Metallic plastic
version as this material is a little less flexible and robust than the Strong & Flexible materials.Gyro the Cube
Blowing minds since 2009