Tripod foot for GoPro

Tripod foot for GoPro 3d printed
A tripod foot for the popular GoPro HD camera. It is compatible with the standard waterproof case, and also with my lightweight, open-frame case. The foot has a 1/4"-20tpi standard tripod thread, and additionally 4 mounting holes (3mm) to allow it to be bolted to various surfaces (e.g. FPV airplanes, etc.). I tested this model in White,Strong&Flexible. The thread fits a standard tripod screw quite well - the first time might require some slow and careful tightening to clean up the thread after printing. Don't force it, just unscrew and try again if it gets stuck to remove excess powder. Alumide is still untested, but colour materials should (theoretically) be the ok.
cm: 2 w x 3 d x 1.7 h
in: 0.787 w x 1.181 d x 0.669 h

Comments

 
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $11.90

Favorited by