Trex450 Sonar Mount v1

Trex450 Sonar Mount v1 3d printed Download
Trex450 Sonar Mount v1 3d printed Download Description
Trex450 Sonar Mount v1 3d printed Download Description
Description
Trex450 Sonar Mount v1 3d printed Download Description
Trex450 Sonar Mount v1 3d printed Download Description
Description
3d Model Viewer
Trex450 Sonar Mount v1 3d printed Download
Trex450 Sonar Mount v1 3d printed Download

Mount to allow you to easily attach a Maxbotix sonar to the tail boom of a Trex450 helicopter.

You need four (4) 2mm diameter screws to mount to the tail boom.  You will also need two (2) 3mm screws to attach the sonar to the mount.

It's a little fiddly to attach the mount to that tail because the rod from the tail servo to the tail must pass inside the mount (which isn't too difficult) and also the plastic screws to attach the mount to the tail are a bit tricky to maneuver into place.

cm: 2 w x 3.2 d x 2.6 h
in: 0.787 w x 1.26 d x 1.024 h

Comments

 
 
  • Black Strong & Flexible

    Black nylon plastic with a matte finish and slight grainy feel.

    $8.32

Favorited by