Warden CNC dreadnaught

Warden CNC dreadnaught 3d printed Miniatures SciFi
cm: 3.68 w x 1.8 d x 7.24 h
in: 1.449 w x 0.709 d x 2.85 h

Comments

 
Appologies for the weak structure. I checked on the one I ordered and with a bit of playing mine broke. I just doubled the thickness. Suggestions for fixing. If its broken on both ends use a 0.6-0.8mm drill bit, drill a hole at the correct angle but offset so you can drop a small wire in there to act as a bottom support for when you glue the part back on. Dont bother trying to drill into the loop itself as at 1mm thick the plastic will become too weak to be structural.
August 5, 2012, 9:25 pm
Awesome, will have to get one of these. How about a pantak class vigilante or a Scarren dreadnaught?
August 5, 2012, 1:23 pm
Beautiful design, but the upper loops break off real easily. I had this for only a few hours before both upper loops broke. I suggest making them a little thicker.
May 13, 2012, 2:18 pm
 
  • Frosted Ultra Detail

    Matte translucent plastic that showcases fine and intricate details.

    $23.40

Favorited by