Small snap hinge test

Design by Fingers
    (3) 
    • 2.67 out of 5
    • *
    • *
    • *
    • *
    • *
(2) Comments
Contact Designer
Description
Description
Description
Description
Description
Description
3d Model Viewer
A small hinge joint, five versions with different clearances for testing.
cm: 4.6 w x 2.5 d x 0.5 h
in: 1.811 w x 0.984 d x 0.197 h
Report abuse

Comments

You must login to leave a comment
 
Mechanoid
Mechanoid says:
@Fingers Your design has many possibilities built in to the designs themselves. Wish they were for sale, would like to explorer those nuances at some point.
Reply
April 12, 2013, 6:21 pm
Fingers
Fingers says:
I had two copies printed, interestingly enough it resulted in three different print orientations. This is good as I'll be able to try the same part printed with the layers going in two different directions and find a clearance value that works well for both. The "snap" assembly is intended to facilitate loose tolerances; you have to squeeze the split tab to insert it into the slot, then release it and it holds tightly.
Reply
May 27, 2009, 6:26 pm
 
Not For Sale
Add To Wishlist
Add To Favorites
 
Keywords
assembly blender hinge joint mechanical