Bracket EMG 30

Bracket EMG 30 3d printed Robotics Maker/DIY powertrain for robot
powertrain for robot
Bracket EMG 30 3d printed Robotics Maker/DIY raw material
Bracket EMG 30 3d printed Robotics Maker/DIY raw material
raw material
Bracket EMG 30 3d printed Robotics Maker/DIY with set screws
Bracket EMG 30 3d printed Robotics Maker/DIY with set screws
with set screws
3d Model Viewer
Bracket EMG 30 3d printed Robotics Maker/DIY
Bracket EMG 30 3d printed Robotics Maker/DIY
Bracket EMG 30 3d printed Robotics Maker/DIY with EMG30 motor
Bracket EMG 30 3d printed Robotics Maker/DIY with EMG30 motor
with EMG30 motor
Bracket EMG 30 3d printed Robotics Maker/DIY two motors in frame
Bracket EMG 30 3d printed Robotics Maker/DIY two motors in frame
two motors in frame
Bracket EMG 30 3d printed Robotics Maker/DIY robot frame example
Bracket EMG 30 3d printed Robotics Maker/DIY robot frame example
robot frame example
Bracket EMG 30 3d printed Robotics Maker/DIY real
Bracket EMG 30 3d printed Robotics Maker/DIY real
real
Bracket EMG 30 3d printed Robotics Maker/DIY really
Bracket EMG 30 3d printed Robotics Maker/DIY really
really
Bracket EMG 30 3d printed Robotics Maker/DIY frame really
Bracket EMG 30 3d printed Robotics Maker/DIY frame really
frame really
Bracket EMG 30 3d printed Robotics Maker/DIY
Bracket EMG 30 3d printed Robotics Maker/DIY
Bracket EMG 30 3d printed Robotics Maker/DIY powertrain for robot
Bracket EMG 30 3d printed Robotics Maker/DIY powertrain for robot
powertrain for robot

This mounting bracket can be used to assembly and align the EMG 30 DC gearmotor. (also motors in diameter range from 25 – 33 mm)

The M4 threaded holes for set screws must itself be tapped. The set screws are M4 X 10 (2 X dog point, 1 X cone point)).

The mounting plates can be connected  with use of three M4 threaded rods.

The mounting plates are  designed for use during prototyping phase and not yet tested with external loads.

The center line of the DC motor mounted in a frame that consists of at least two mounting brackets and three threaded rods by means of two three set screws in any direction to make.


cm: 4.6 w x 4.998 d x 0.7 h
in: 1.811 w x 1.968 d x 0.276 h

Comments

 
 
  • Sandstone

    Delicate and grainy, with a coarse finish and sand-like color.

    $6.15