d9 - Two Fudge Dice in One!

d9 - Two Fudge Dice in One! 3d printed Dice
In the “Fudge” gaming system, one commonly rolls four dice, each numbered with “+”, “-”, and “0”.  Since those are d3, and 2d3 are equivalent to a d9, you can emulate a Fudge roll with two of these dice (each one substituting for 2d3) without changing the odds.

I'm not sure about the numbering for this die.  Using “++” and “--” didn't look so good for the double-plus/minus points, but “+1”/“-1” didn't look so good on the single-plus/minus spots.  So there's sort of a hybrid notation here: one face reads “+2”, and one reads “-2”, then there are two labeled “+” and two labeled “-”, and then three labeled “0”, in order to emulate the odds of 2dF properly.  The single “+” and “-” signs are designed to look different from one another even in bad printing (but the proof will be in the actual printing).

The die is hollow, for minimal volume and smaller rotational inertia, and also has thinner curved sections than my other d9s, so hopefully should not roll too long.
Tags:
Dice, d9, dice, die
cm: 2.856 w x 3.114 d x 2.858 h
in: 1.124 w x 1.226 d x 1.125 h

Comments

 
Awesome design!
May 16, 2012, 5:25 am
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $5.24

Favorited by