Introducing 14k Gold, read more on the blog.

GoPro bracket for SteadiCam Smoothee

  • White

    White nylon plastic with a matte finish and slight grainy feel.

    $18.26

Mount your GoPro camera on a SteadiCam Smoothee, now you have a waterproof camera on a steadicam.. let the fun begin. Steadicam at the beach, the pool or in the pouring rain.

Mount your GoPro upright and straight,  the ability to angle the camera do not do anything useful as the camera fisheye lens will see the bracket if you look down with it.

Note - the bracket should have a tight fit, it should snap into the Smoothee with a light amount of force, however there is a bit of tolerance/error in wall accuracy when 3D printing, if it is any harder than that, gently sand the edges and side of the bracket slightly and try again. The tight fit is important to prevent vibrations.

You can use this with both a regular GoPro and also with the GoPro with display backpack. some balancing required, you should not purchase this unless you understand the basics of balancing your SteadiCam Smoothee.

The balance with the display backpack is amazing, the original iPhone mount with phone is about 228grams and the GoPro with display and mount is about 226 grams, this works very well.

SteadiCam Smoothee is a trademark of Tiffen, this product have no relationship to Tiffen or SteadiCam, it is a aftermarked accessory bracket for the GoPro camera.

Using Strong & Flexible material, I drilled the shape out a bit to save some material.

Dimensions

IN: 1.252 w x 1.252 d x 1.252 h
CM: 3.18 w x 3.4 d x 2.8 h

Comments

 
Sorry for the delay - I have added a Smoothee 1/4 screw mount - http://www.shapeways.com/model/635220
July 17, 2012, 12:22 am
this item is good. but if this item made to in the bottom 1/4 inch screw driver is very very good!! Do you make them happen?
July 16, 2012, 11:32 pm