Front side. The model is not fully cleaned and is partly deteriorated after brushing.
Front side. The model is not fully cleaned and is partly deteriorated after brushing.
Not full cleaned and deteriorated after brushing.
Detail of the 0.3 mm holes of one of the halves. This model came with a fissure (Shapeways is reprinting it and sent me this failed print for testing).
A level-4 Menger sponge 0.3mm wall-thickness. Only available in Frosted Ultra Detail.
Due to the small size of the holes, they get full of the wax of the support structure and must be removed with warm water or any product that disolves the wax without affecting the FUD material. Brushing can destroy the walls.
Check also the level-3 one: http://www.shapeways.com/model/245325/menger_frosted.html
Due to the small size of the holes, they get full of the wax of the support structure and must be removed with warm water or any product that disolves the wax without affecting the FUD material. Brushing can destroy the walls.
Check also the level-3 one: http://www.shapeways.com/model/245325/menger_frosted.html
cm:
2.43 w x
2.43 d x
2.43 h
in:
0.957 w x
0.957 d x
0.957 h
Select Country
$ United States
Material Options
-
Frosted Ultra Detail
$22.08
-
Frosted Ultra Detail
$22.08
Comments