Kinect Tripod Mount

Kinect Tripod Mount 3d printed Accessories Gadgets
Kinect Tripod Mount 3d printed Accessories Gadgets front view
Kinect Tripod Mount 3d printed Accessories Gadgets front view
front view
Kinect Tripod Mount 3d printed Accessories Gadgets rear view
Kinect Tripod Mount 3d printed Accessories Gadgets rear view
rear view
3d Model Viewer
Kinect Tripod Mount 3d printed Accessories Gadgets
Kinect Tripod Mount 3d printed Accessories Gadgets
This is a mount for attaching an Microsoft Kinect sensor to a standard 1/4"x20tpi tripod screw. It requires no modification to your Kinect -- it clamps around the base instead of requiring you to tap screws into the bottom of the Kinect.

You will need a single  1/4"x20tpi jam nut to use this mount.    Assembly instructions are here: http://www.thingiverse.com/thing:6930.

IMPORTANT:  The holes for the jam nut and screw are deliberately undersized due to the variations in tripod mounts and jam nuts.  You'll need to use a hobby knife to open it up and make it fit your particular rig.

This version is for installations where the Kinect is mostly in the normaly horizontal plane.  We are working on a new version to handle 90 degree and 180 degree (upside down) installations.


cm: 5.608 w x 12.228 d x 2 h
in: 2.208 w x 4.814 d x 0.787 h

Comments

 
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $37.92