Flying Alien Monster

 A large flying monstrous creature suitable for use in most 28mm minature games. Stands about 8cm tall at the head depending on pose. Wingspan is approximately 14cm. The torso, legs, and head are partially hollowed out with 1.5mm walls to reduce printing cost and model weight (for reduced tippy-base syndrome!)

This figure has ball jointed limbs, tail, and head makeing posing or accessorizing easy. It should be compatible with most bitz used in your game of choice. Some mounting with epoxy or "green stuff" might be required for a snug fit depending on what you're attempting to mount on the models.

For crisp detail I recommend printing this one in a "detail" material, but WSF will look just fine and should be good if you're intending extensive modifications that will cover up the grain. For painting, I find that printing in Black Detail works best, as it doesn't require any basecoating that would obscure detail work. Transparent Detail provides a nice opportunity with thisone, as the wings should remain nicely translucent with a bit of inking.

If you're looking to add on to an existing figure, the wings are available seperately here: https://www.shapeways.com/model/219896/ragged_monster_wings.html?gid=ug71173