Rune Ring - Odin v1a

Rune Ring - Odin v1a 3d printed Here's a sample printed in Steel and another printed in Polished Bronze.
Here's a sample printed in Steel and another printed in Polished Bronze.
Rune Ring - Odin v1a 3d printed Here's a sample printed in Steel and another printed in Polished Bronze.
Rune Ring - Odin v1a 3d printed Here's a sample printed in Steel and another printed in Polished Bronze.
Here's a sample printed in Steel and another printed in Polished Bronze.
Rune Ring - Odin v1a 3d printed Here's a sample printed in Steel and another printed in Polished Bronze.
Rune Ring - Odin v1a 3d printed Here's a sample printed in Steel and another printed in Polished Bronze.
Here's a sample printed in Steel and another printed in Polished Bronze.
3d Model Viewer
Rune Ring - Odin v1a 3d printed
Rune Ring - Odin v1a 3d printed
It's hand translated by an amature (me), so it might not be completely accurate, but the characters should read, "Awaken my Power Father God Odin". The inside is smoothed, to make it easier to wear.
cm: 2.796 w x 0.934 d x 2.788 h
in: 1.101 w x 0.368 d x 1.098 h

Comments

 
I would very much like to buy one if it could be sized.
January 16, 2012, 7:48 pm
If you wanted to make one the same size as your Mecha ring, I'd get one eventually!
May 13, 2011, 8:03 am
According to my Calipers, it'll fit 21mm inside. Those same calipers show the large Mecha ring to be 24mm. Looks like that'd be a pinky ring for you. I could make it bigger though, if you'd like. I might make it thinner as well....
May 5, 2011, 5:40 am
What size is it? I have your sz 15 Mecha ring and it fits me beautiful on my middle finger.
May 2, 2011, 9:11 pm
 
  • Stainless Steel

    Bronze-infused stainless steel with visible print lines and rough feel.

    $19.44

Favorited by