"Backlash" Gunslinger figure

by Drawn-SteelHero
"Backlash" Gunslinger figure 3d printed Figurines SciFi Robot mode, view 1
Robot mode, view 1
  • White

    White nylon plastic with a matte finish and slight grainy feel.

Buy Now
Powerful hand-held acid blaster rifle converts into a 56mm robot action figure with 9 points of articulation.

Gun mode comes with a choice of three handles, any of which can be glued in to the mounting point on the figure's back.
Option 1 is a standard 5mm post, which is compatible with any figure bearing a 5mm peg hole.
Option 2 is a modified version of the post, which can still be used by figures with 5mm peg holes, but also has a built-in clip which allows it to clip onto any 3mm diameter rail.
Option 3 is a two-stage post, which like Option 1, can fit into any 5mm peg hole, but also has a narrowed end allowing it to be used by figures with 4mm diameter peg holes.

Newly redesigned hands are able to hold or clip onto any 3mm diameter rod.
A new hinge design means  this figure is now available to be printed in the Detail materials as well as WSF. However, WSF Polished is recommended for the best combination of durability and smoothness.

Supplied as a 14-piece kit. Finishing (painting/dyeing) required, alternatively can be purchased in one of the available pre-dyed colours.

Assembly instructions coming soon...


IN: 2.557 w x 0.537 d x 2.995 h
CM: 6.496 w x 1.364 d x 7.608 h


Sign In or Join to comment.
Great, thanks for the solution :)
April 20, 2011, 9:02 pm
It should do, yes. Most of the joints are actually designed with zero clearance, but when printed there tends to be a little give between the parts. If you find they're still loose after you've painted and sealed it, try applying a tiny amount of superglue to the male part of the joint and spreading it around, and leave it aside to cure before reassembling it.
April 11, 2011, 11:25 pm
Not a bad design, but the whole thing is pretty floppy. It could use a bit of tightening. Perhaps the paint would serve this purpose.
April 11, 2011, 8:36 pm


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.