This model is just the clamp and it has no practical value without one of my screen cradles! I recommend the "Strong and Flexible" plastics for the clamp. The detail plastic can get a little brittle. The clamp snaps onto the back of the screen cradle of your choice to secure the screen and chip. This integrated two piece clamping system for the DNA20/30 does not require any glue or epoxy of the electronic components. You will still need to adhere the screen cradle to whatever case you end up using for your build.

Dimensions

IN: 1.287 w x 0.736 d x 0.375 h
CM: 3.27 w x 1.87 d x 0.952 h

Comments

Sign In or Join to comment.
 
@Lash151 Sorry you had problems. There are literally hundreds of these in use and you are one of the very few reported issues. 3D printing isn't perfect yet so sometimes you get a bad print. I'm just the designer so the production and printing are out of my control.
June 19, 2014, 1:46 pm
Poor quality... The DNA board was a very tight fit and the tabs snapped.
June 19, 2014, 1:06 pm
Thanks for the review and trying it out @Cajunvapor!
April 9, 2014, 6:44 pm
If you were wondering if this works I have one it fits perfect it's fits good with the screen cradle
April 9, 2014, 6:42 pm
 
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.